Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentForce10 S2410-01-10GE-24P

271

272

273

274

275

276

277

278

279

280

IGMP Snooping Commands | 277

Mode

Interface Config;Interface Port Channel Config; Interface Vlan Config; Interface Range, which is

indicated by the (conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.

Command

History

igmp mcrtexpiretime (interface)

This command sets the Multicast Router Present Expiration time on a selected interface.

Syntax

igmp mcrtexpiretime 0-3600

The variable is the amount of time in seconds that a switch will wait for a query to be received on an

interface before the interface is removed from the list of interfaces with multicast routers attached. The

range is 0 to 3600 seconds. A value of 0 indicates an infinite timeout, i.e. no expiration.

The no igmp mcrtexpiretime command sets the Multicast Router Present Expiration time on the

interface to 0. A value of 0 indicates an infinite timeout, i.e. no expiration.

Default

Mode

Interface Config; Interface Port Channel Config; Interface Range, which is indicated by the

(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.

Command

History

igmp mrouter

This command configures the VLAN ID (vlanId) that has the multicast router mode enabled.

Syntax

[no] igmp mrouter vlanId

The no version of this command disables multicast router mode for a particular VLAN ID (vlanId).

Version 2.5.1 Modified: Added Interface Port Channel Config mode.

Version 2.3

Modified: Revised from

set igmp maxresponse. Added Interface Range and Interface

Vlan Config modes.

Commands

igmp enable (interface) Enables IGMP Snooping on a selected interface.

interface range Defines an interface range and accesses the Interface Range mode

interface Identifies an interface and enters the Interface Config mode.

show igmpsnooping Displays IGMP Snooping status information.