Quick Reference Guide

252 | GARP Commands
www.dell.com | support.dell.com
The no version of this command sets the GVRP join time per port and per GARP to 20 centiseconds
(0.2 seconds). This command has an effect only when GVRP is enabled.
Default
20 centiseconds
Mode
Interface Config, Global Config; Interface Port Channel Config; Interface Range, which is indicated by
the (conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
set garp timer leave
This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service.time is 20 to 600 (centiseconds). The value 60 centiseconds is 0.6
seconds.
Syntax
set garp timer leave 20-600
Use no set garp timer leave to set the GVRP leave time per port to 60 centiseconds (0.6 seconds).
Default
60
Mode
Interface Config; Interface Port Channel Config; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Added Interface Port Channel Config mode
Unsupported: not tested in 2.5.1
Version 2.3 Interface Range mode added
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
Note: This command has an effect only when GVRP is enabled.
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Added Interface Port Channel Config mode
Unsupported: not tested in 2.5.1
Version 2.3 Interface Range mode added
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode