Quick Reference Guide

Time Commands | 243
14
Time Commands
Use the commands in this chapter to configure and monitor time and date on the switch. You can
manually set the system clock or use SNTP (see SNTP Commands on page 244).
• clock time on page 243
• show clock on page 243
• sntp broadcast client poll-interval on page 244
• sntp client mode on page 245
• sntp client port on page 245
• sntp unicast client poll-interval on page 245
• sntp unicast client poll-timeout on page 246
• sntp unicast client poll-retry on page 246
• sntp server on page 246
• show sntp on page 247
• show sntp client on page 248
• show sntp server on page 248
System Clock Commands
clock time
This command manually sets the system clock, configuring the date and/or time.
Syntax
OgeORuCa,Eu{dd/mm/yyyy | hh:mm:ss}
Enter the date in dd/mm/yyyy format (for example, 10/01/2007 for October 1, 2007) or the time in
hh:mm:ss format (for example, 22:45:00, for 10:45 P.M.).
Default
If you enter only one parameter (either date or time), leaving the other parameter unchanged, the
unchanged parameter continues to be based on the previous command execution.
Mode
Global Config
Command
History
show clock
This command is used to display clock settings and status.
Syntax
show clock
Version 2.5.1.0 Introduced