Quick Reference Guide

234 | DHCP Server Commands
www.dell.com | support.dell.com
dns-server
This command specifies the IP servers available to a DHCP client. Address parameters are valid IP
addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
The no version of this command removes the DNS Server list.
Syntax
dns-server address1 [address2....address8]
no dns-server
Default
none
Mode
DHCP Pool Config
domain-name
This command specifies the domain name for a DHCP client. The domain specifies the domain name
string of the client.
The no version of this command removes the domain name.
Syntax
domain-name domain
Default
none
Mode
DHCP Pool Config
hardware-address
This command specifies the hardware address of a DHCP client.
The hardware-address is the MAC address of the hardware platform of the client consisting of 6
bytes in dotted hexadecimal format.
The type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
The no version of this command removes the hardware address of the DHCP client.
Syntax
[no] hardware-address hardware-address [type]
Default
ethernet
Mode
DHCP Pool Config