Quick Reference Guide

226 | Stacking Commands
www.dell.com | support.dell.com
Slot and Card Commands
This section provides detailed explanations of the slot and card commands:
• set slot disable on page 226
• set slot power on page 226
• show slot on page 226
• show supported cardtype on page 227
• slot on page 229
set slot disable
Command
History
set slot power
Command
History
show slot
This command displays information about all the slots in the system, or, when the unit/slot argument is
included, this command displays information for the requested slot in the specified stack member. If
that slot holds a card or module, information about the contents of the slot is also displayed.
Syntax
show slot [unit/slot]
Mode
User Exec; Privileged Exec
Example
Figure 12-82. Using the show slot command
Figure 12-82 shows three S50 switches in a stack. “Slot” 1/0 indicates with “Full” in the Status column
that the unit contains a 10Gb module.
Report Fields
Slot—This field displays the slot identifier in a unit/slot format.
Slot Status—This field indicates whether the slot is empty, full, or has encountered an error.
Version 2.3 Replaced by the slot command.
Version 2.3 Replaced by the slot command.
Force10 #show slot
Admin Power Configured Card Hot Power
Slot Status State State Model ID Pluggable Down
----- ------ ------- ------- -------------------------------- --------- -----
1/0 Full Enable Enable SA-01-10GE-2P No No
2/0 Empty Enable Disable SA-01-10GE-2P No No
3/0 Empty Enable Disable SA-01-10GE-2P No No