Quick Reference Guide

220 | Stacking Commands
www.dell.com | support.dell.com
Configured Stack Mode—Stack or Ethernet
Stack Mode—Stack or Ethernet
Link Status—Status of the link
Link Speed—Speed (Gb/s) of the stack port link
Example 2
The S50V has two expansion slots for up to four stacking ports, so this report is set up to display all
four ports, as shown in Figure 12-77, whether or not all are installed (in this case, only a 10G XFP
module is installed, but it is not linked). The ports are numbered left to right as you face them on the
back of the chassis.
Figure 12-77. Example of Output from the show stack-port counters Command on an
S50V
When the counters argument is used, the report contains the following fields:
Unit—Unit
Interface—Stack port number (A or B)
Tx Data Rate—Transmit data rate in megabits per second on the stacking port
Tx Error Rate—Platform-specific number of transmit errors per second
Tx Total Errors—Platform-specific number of total transmit errors since power-up
Rx Data Rate—Receive data rate in megabits per second on the stacking port
Rx Error Rate—Platform-specific number of receive errors per second
Rx Total Errors—Platform-specific number of total receive errors since power-up
show stack-port diag
This command shows stacking diagnostics for each port and is only intended for Field Application
Engineers (FAEs) and developers. An FAE will advise on the necessity to run this command and
capture this information.
Syntax
show stack-port diag
Mode
Privileged Exec
Unit—Unit
Force10-S50V#show stack-port counters
------------TX-------------- ------------RX--------------
Data Error Data Error
Rate Rate Total Rate Rate Total
Unit Interface (Mb/s) (Errors/s) Errors (Mb/s) (Errors/s) Errors
---- ---------------- ------ ---------- ---------- ------ ---------- ----------
1 0/49 0 0 0 0 0 0
1 0/50 0 0 0 0 0 0
1 0/51 0 0 0 0 0 0
1 0/52 0 0 0 0 0 0