Quick Reference Guide

218 | Stacking Commands
www.dell.com | support.dell.com
Command
History
Related
Commands
archive download-sw
This command downloads the SFTOS software image (.OPR file) to the switch. The url is the transfer
mode. The switch must be reset for the new code to start running.
Syntax
archive download-sw url
Mode
Stacking Config (prompt is “(config-stack)#”)
Command
History
Related
Commands
member
This command is optional. The command is executed on the management unit to pre-configure the
stacking characteristics of a switch that will join the stack.
Syntax
member unit switchindex
The unit is the stack ID (from 1 to 8) to which you want to assign the switch that you are
adding to the stack. The ID must be a currently unused number.
The
switchindex is the SID number of the supported switch type that is displayed by show
supported switchindex, indicating the type of the switch being preconfigured.
Use no member unit to remove the specified switch from the stack.
Mode
Stacking Config (prompt is “(config-stack)#”)
Related
Commands
Version 2.5.1 Deprecated
copy Copy software from the stack management unit to a stack member.
copy {image1 | image2} unit://unit/{image1 | image2}
Version 2.5.1 Deprecated
copy Download software to the stack management unit.
copy tftp://tftp_server_ip_address/path/filename {image1 | image2}
Note: The required switch index (SID) can be obtained by executing the show supported
switchtype command in User Exec or Privileged Exec mode.
show supported switchtype
Displays the switch index (SID) of supported switches
stack
Accesses the Stacking Config mode