Quick Reference Guide

Stacking Commands | 217

Stacking Commands

This chapter provides a detailed explanation of the stacking commands. The commands are listed

under two headings:

• Stacking on page 217

• Slot and Card Commands on page 226

See also the copy and Dual Image Management Commands on page 119 in the System Configuration

chapter.

Stacking

This section provides detailed explanations of the commands that manage the stacking of S-Series

switches into a single virtual switch:

• archive copy-sw on page 217

• archive download-sw on page 218

• on page 218

• movemanagement on page 219

• reload on page 219

• show stack-port on page 219

• show stack-port diag on page 220

• show switch on page 221

• show supported switchtype on page 223

• stack on page 224

• switch priority on page 225

• switch renumber on page 225

archive copy-sw

This command replicates the SFTOS software image (.OPR file) from the management unit to the

other switch(es) in the stack. The code is loaded on the destination system unit, if specified, otherwise

the code is loaded on all switches in the stack. Switch(es) must be reset for the new code to start

running.

Syntax

sOiabEuOedI6nAudestination-system unit

Mode

Stacking Config (prompt is “(config-stack)#”)

Note: This command must be executed only if the new unit is added to a stack that is running

a different version than the management unit.