Quick Reference Guide

186 | Security Commands
www.dell.com | support.dell.com
show port-security
This command displays the port-security settings for a particular interface or for the entire system.
Syntax
show port-security [unit/slot/port | all]
Mode
Privileged Exec
Report Fields When no parameter is entered, the one report field is:
Port Security Administration Mode—Port-locking mode for the entire system
As shown in Figure 11-65 on page 186, when either the unit/slot/port or all parameter is entered, the
report fields are:
Intf — Port number (unit/slot/port)
Admin Mode — Whether the interface is administratively Enabled or Disabled
Dynamic Limit—Maximum dynamically allocated MAC Addresses
Static Limit—Maximum statically allocated MAC Addresses
Violation Trap Mode—Whether violation traps are Enabled or Disabled
Example
Figure 11-65. Example of show port-security all Command Output
•
•
Force10 #show port-security all
Admin Dynamic Static Violation
Intf Mode Limit Limit Trap Mode
--------- ------- ---------- --------- ----------
1/0/1 Disabled 600 20 Disabled
1/0/2 Disabled 600 20 Disabled
1/0/3 Disabled 600 20 Disabled
1/0/4 Disabled 600 20 Disabled
1/0/5 Disabled 600 20 Disabled
1/0/6 Disabled 600 20 Disabled
1/0/7 Disabled 600 20 Disabled
1/0/8 Disabled 600 20 Disabled
1/0/9 Disabled 600 20 Disabled
1/0/10 Disabled 600 20 Disabled
1/0/11 Disabled 600 20 Disabled
1/0/12 Disabled 600 20 Disabled
1/0/13 Disabled 600 20 Disabled
1/0/14 Disabled 600 20 Disabled
1/0/15 Disabled 600 20 Disabled
1/0/16 Disabled 600 20 Disabled
1/0/17 Disabled 600 20 Disabled
1/0/18 Disabled 600 20 Disabled
--More-- or (q)uit
!--output truncated--!
Related
Commands
show port-security dynamic Displays the dynamically locked MAC addresses for port
show port-security static Displays the statically locked MAC addresses for port
show port-security violation Displays the source MAC address of the last packet that was discarded on a
locked port