Quick Reference Guide

18 | Quick Start
www.dell.com | support.dell.com
System Info and System Setup
To get information on the software version, use the show hardware command:
Physical Port Data
To get information on the physical port, use the show port all command:
User Account Management
To configure account management, use the following commands:
Command Syntax Command Mode Purpose
show hardware
Privileged Exec Displays the serial number, software version the device contains,
burned-in MAC address, and other device information. Information is
listed for all units in the stack.
Command Syntax Command Mode Purpose
show port all
Privileged Exec
Displays the ports in
unit/slot/port format and the following data for
each port:
Type - Indicates if the port is a special type of port
Admin Mode - Selects the Port Control Administration State
Physical Mode - Selects the desired port speed and duplex mode
Physical Status - Indicates the port speed and duplex mode
Link Status - Indicates whether the link is up or down
Link Trap - Determines whether or not to send a trap when link status
changes
LACP Mode - Displays whether LACP is enabled or disabled on this port.
Command Syntax Command Mode Purpose
show users
Privileged Exec Displays all of the users that are allowed to access the switch
Access Mode - Shows whether the user is able to change parameters on
the switch (Read/Write) or is only able to view them (Read Only).
As a factory default, the ‘admin’ user has Read/Write access. There can
only be one Read/Write user and up to five Read Only users.
show loginsession
Privileged Exec Displays all of the login session information