Quick Reference Guide

Link Layer Discovery Protocol (LLDP) Commands | 167
Example
Figure 8-59. Example Output from show lldp neighbors Commands
show lldp remote-device
Display LLDP configuration for all interfaces.
Syntax
show lldp remote-device {all | unit/slot/port}.In an SVL system, the [fdbid/all] parameter is not
used and will be ignored if entered.
Default
none
Mode
Privileged Exec
Command
History
(S50) #show lldp neighbors interface 1/0/1
Local Intf Dead Interval Remote Intf ChassisID Tx Rx
1/0/1 24 2/0/3 S50-2 123 23
S50# show lldp neighbors interface 1/0/2 detail
Local Interface: 1/0/2 Remote Interface: 2/0/4
Dead Interval: 14 seconds Tx: 51 Rx: 224
Remote Chassis ID: 2
Remote Interface Description: Interface Description
System Name: S50-2
System Description: Best Ethernet Switch
System Capabilities: Router, Switch
Software Version: 2.5.1 Hardware Version:
IPv4 Address: 10.1.1.1 IPv6 Address: 2000::1 Vlan: 10
Speed & Duplex: 1000 Mbps Full
PoE Capable: No
Related
Commands
lldp mode (global) Enable/disable LLDP globally.
lldp mode (interface) Enable/disable LLDP on a selected interface.
clear lldp neighbors Clear LLDP neighbor information.
Parameters
interface unit/slot/port For a particular interface, enter its ID in unit/slot/port format.
all Enter the keyword all for all interfaces.
Version 2.5.1 Introduced