Quick Reference Guide

164 | Link Layer Discovery Protocol (LLDP) Commands
www.dell.com | support.dell.com
Default
not enabled
Default
2
Mode
Interface Config
Command
History
show lldp interface
Display LLDP configuration for all interfaces.
Syntax
show lldp interface {all | unit/slot/port}.In an SVL system, the [fdbid/all] parameter is not used
and will be ignored if entered.
Default
none
Mode
Privileged Exec
Command
History
Parameters
port-desc
Include/Exclude LLDP port description TLV (the description configured for
the transmitting port using the
description command within the Interface
Config mode).
sys-cap
Include/Exclude LLDP system capabilities TLV (general info about this
switch, e.g. ‘switch, router’; not configurable).
sys-desc
Include/Exclude LLDP system description TLV (the system description that
also appears in
show run; not configurable).
sys-name
Include/Exclude LLDP system name TLV (the system name as configured
globally by the
snmp-server name command).
Version 2.5.1 Introduced
Related
Commands
lldp hello The interval in seconds to transmit local LLDP data
lldp multiplier The interval multiplier to set local LLDP data TTL
lldp notification Minimum interval to send remote data change notifications
show running-config Display current settings with values that differ from the default value.
Parameters
interface unit/slot/port For a particular interface, enter its ID in unit/slot/port format.
all Enter the keyword all for all interfaces.
Version 2.5.1 Introduced