Quick Reference Guide

VLAN Commands | 153
Syntax
mode dot1q-tunnel
Default
disabled
Mode
Interface Config
Command
History
Usage
Information
By default, all ports become core ports. To configure a particular port as an access port, enable
DVLAN tagging in Interface Config mode for that port with this command.
Related
Commands
mode dvlan-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface. By default,
Double VLAN Tunneling is disabled.This command performs the same function as mode
dot1q-tunnel.
The no version of this command is used to disable Double VLAN Tunneling on the specified interface.
By default, Double VLAN Tunneling is disabled.
Syntax
mode dvlan-tunnel
Default
disabled
Mode
Interface Config; Interface Port Channel Config
Command
History
Usage
Information
By default, all ports become core ports. To configure a particular port as an access port, enable
DVLAN tagging in Interface Config mode for that port with this command.
Related
Commands
Version 2.5.2 Unsupported: This command was not tested in SFTOS 2.5.2, so is not supported
Version 2.5.1 Unsupported: This command was not tested in SFTOS 2.5.1, so is not supported
show dot1q-tunnel Displays information about Double VLAN Tunneling for a specified
interface or for all interfaces.
show dvlan-tunnel
l2pdu-forwarding
Displays the current l2pdu tunneling configuration present on the switch.
Version 2.5.2 Unsupported: This command was not tested in SFTOS 2.5.2, so is not supported
Version 2.5.1 Modified: Added Interface Port Channel Config mode.
Unsupported: This command was not tested in SFTOS 2.5.1, so is not supported
show dot1q-tunnel Displays information about Double VLAN Tunneling for a specified
interface or for all interfaces.
show dvlan-tunnel
l2pdu-forwarding
Displays the current l2pdu tunneling configuration present on the switch.