Quick Reference Guide

142 | VLAN Commands
www.dell.com | support.dell.com
Default
enabled
Mode
Interface VLAN
Command
History
Related
Commands
vlan association subnet
This command configures an IP subnet-based VLAN by associating the VLAN with an IP address and
subnet mask.
The no version of this command removes the association of the VLAN with the specified IP address
and subnet mask.
Syntax
[no] vlan association subnet ipaddr netmask
For ipaddr and netmask, enter the IP address and subnet mask, used as the basis for the VLAN.
Default
enabled
Mode
Interface VLAN
Command
History
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Introduced
interface vlan Creates a new VLAN, or selects one based on ID, and then enters the Interface
VLAN mode, which provides access to VLAN configuration commands for the
specified VLAN.
show mac-addr-table Displays forwarding database entries, including MAC addresses by VLAN.
show port Displays port information for a selected port or for all ports
show interfaces Displays information about a selected interface or VLAN.
show vlan Displays information about VLANs, either detailed information for a specific
VLAN or summary information for all configured VLANs.
show vlan association
mac
Displays information about either all MAC-based VLANs or the VLAN associated
with a specific MAC address.
show vlan association
subnet
Displays information about either all IP subnet-based VLANs or the VLAN
associated with a specific IP address and mask.
Note: The S50V and S25P support IP subnet-based VLANs. The original S50 does
not.
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Introduced