Quick Reference Guide

VLAN Commands | 141
Command
History
Usage
Information
The untagged command includes the functionality of these commands: participation include,
pvid, and acceptframe untagged. For details, see the VLAN chapter in the SFTOS Configuration
Guide.
Related
Commands
vlan
Command
History
vlan acceptframe
This command sets the frame acceptance mode per interface.
Mode
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as
(conf-if-range-vlan 10-20)#.
Command
History
Related
Commands
vlan association mac
This command configures a VLAN based on a set of MAC addresses, source and destination.
The no version of this command removes the association of the VLAN with the specified MAC
address.
Syntax
[no] vlan association mac mac
For mac, enter a source MAC address to be used as the basis for the VLAN.
Version 2.5.1 Modified: Added ranges for ports and port channels. Added Interface Range Vlan Config
mode.
Version 2.3 Introduced
show vlan Displays information about VLANs, either detailed information for a specific
VLAN or summary information for all configured VLANs.
show port Displays port information for a selected port or for all ports
tagged Sets tagging to enabled for a specified interface in the selected VLAN.
Version 2.3 Modified: Replaced by interface vlan.
Version 2.5.1 Removed from CLI
Version 2.3 Deprecated
untagged Sets tagging to disabled for a specific port (or range of ports) in the selected VLAN.
Note: The S50V and S25P support MAC-based VLANs. The original S50 does not.