Quick Reference Guide

140 | VLAN Commands
www.dell.com | support.dell.com
Usage
Information
The tagged command includes the functionality of the vlan participation include command and
the vlan acceptframe vlanOnly command. For details, see the VLAN chapter in the SFTOS
Configuration Guide.
The tagged command cannot be applied to ports in VLAN 1, which is the default VLAN.
Example
Figure 7-48. Using the tagged Command
Related
Commands
untagged
This command adds a Layer 2 interface to the selected VLAN as an untagged interface.
Syntax
[no] untagged {intf-range | port-channel port-channel-range}
To remove an untagged interface from the VLAN, use the no version of the command.
The no option adds the designated interface(s) to the native VLAN. The command sets an acceptframe
type of the interface to “all”. For details, see the Native VLAN section of the VLAN chapter in the
SFTOS Configuration Guide.
Parameters
Mode
Interface VLAN
Force10#config
Force10 (Config)#interface vlan 2
Force10 (Conf-if-vl-2)#tagged 1/0/20-1/0/22 native
Force10 (Conf-if-vl-2)#tagged port-channel 1,3
Force10 (Conf-if-vl-2)#
show vlan Displays information about VLANs, either detailed information for a specific
VLAN or summary information for all configured VLANs.
show port Displays port information for a selected port or for all ports
interface vlan Creates a VLAN or selects an already-created VLAN.
vlan participation
(management VLAN
only)
Change the management VLAN of the switch.
vlan port tagging all Sets the tagging behavior for all interfaces in a VLAN to enabled.
intf-range
Enter one port (unit/slot/port format) or a list of ports. Use a hyphen to
designate a range of ports in this format:
unit/slot/port-unit/slot/port
For nonconsecutive ports, separate each unit/slot/port with a comma and
no spaces before or after the comma.
Note: The range of interfaces can go across members in a stack.
port-channel
port-channel-range
If you do not enter a port (range), enter port-channel followed by one or
more port channel numbers, following the hyphen and comma rules
described above, for example port-channel 1,3.