Quick Reference Guide

136 | VLAN Commands
www.dell.com | support.dell.com
Usage
Information
For the show vlan id vlan-id command, the output is shown in the following example:
Example
Figure 7-44. Output of the show vlan id Command
Description of the fields in the show vlan id report:
VLAN Id: VLAN number
Status: A VLAN is active only if the VLAN contains interfaces and those interfaces are operationally
up.
Q: (T) tagged or (U) untagged information
Ports: Speed - whether it is 10G, 1G or fast Ethernet interface and port number (unit/slot/port).
The “^” indicates the native VLAN.
“Po” indicates a port channel (also called a LAG)
show vlan association mac
This command displays the information about either all IP subnet-based VLANs or the VLAN
associated with a specific IP address and mask.
Syntax
show vlan association mac [mac]
Parameters
Mode
Privileged Exec
Command
History
Usage
Information
Examples of using the show vlan association mac command, with and without the mac variable,
are shown in Figure 7-45.
Force10#R1 #show vlan id 2
Codes: * - Default VLAN, G - GVRP VLANs, E - Ethernet interface, ^ - Native Vlan
VlanId Status Q Ports
------ --------- - --------
2 Active U E ^1/0/20,^1/0/21,^1/0/22,^1/0/24
T E 1/0/40, 1/0/42, 1/0/43, 1/0/44
U ^Po1 ( 1/0/35, 1/0/36, 1/0/37)
U ^Po2 ( 1/0/10)
U ^Po3 ( 1/0/15)
Note: The S50V and S25P support MAC-based VLANs. The original S50 does not.
mac (OPTIONAL) For mac, enter the MAC address to be used for retrieving
information about the associated VLAN.
Version 2.5.1 Introduced