Quick Reference Guide

VLAN Commands | 133
The no version of this command removes the interface from this protocol-based VLAN group that is
identified by this groupid.
Syntax
[no] protocol vlan group groupid
Default
None
Mode
Global Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as
(conf-if-range-vlan 10-20)#.
Command
History
Related
Commands
protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by groupid.
A group may have more than one interface associated with it. Each interface and protocol
combination can only be associated with one group. If adding an interface to a group causes
any conflicts with protocols currently associated with the group, this command will fail and
the interface(s) will not be added to the group.
The referenced VLAN should be created prior to the creation of the protocol-based VLAN except
when GVRP is expected to create the VLAN.
The no version of this command removes all interfaces from this protocol-based VLAN group that is
identified by this groupid.
Syntax
[no] protocol vlan group all groupid
Default
None
Mode
Global Config
Command
History
pvid (VLAN)
Configure the VLAN ID for a specific port.
Command
History
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Unsupported: not tested in 2.5.1
Version 2.3 Added Interface Range mode.
interface range Defines an interface range and accesses the Interface Range mode
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Unsupported: not tested in 2.5.1
Version 2.5.1 Removed from CLI
Version 2.3
Deprecated. Use the
untagged command.