Quick Reference Guide

VLAN Commands | 127
• vlan port ingressfilter all on page 144
• vlan port pvid all on page 144
• vlan port tagging all on page 145
• vlan protocol group on page 145
• vlan protocol group add protocol on page 146
• vlan protocol group remove on page 146
• vlan pvid on page 146
• vlan tagging on page 147
clear vlan
This command resets VLAN configuration parameters to the factory defaults.
Syntax
clear vlan
Default
disabled
Mode
Privileged Exec
Related
Commands
description
Enter a description for the selected interface (port or VLAN).
Syntax
[no] description description
The description allows spaces if you surround the statement with single or double quotes.
Default
none
Mode
Interface VLAN; Interface Config
Command
History
Note: For information on commands related to the management VLAN, see General System
Management and Information Commands on page 35 (most specifically, interface
managementethernet on page 38) in the Management chapter.
For general instructions on configuring the management VLAN, see the Management
chapter in the SFTOS Configuration Guide.
For other VLAN information in the SFTOS Configuration Guide, see the Creating
VLANS section of the Getting Started chapter, the chapters on STP, GARP and
GVRP, IGMP Snooping, and the VLAN section of the Layer 3 Routing chapter.
show vlan Displays information about VLANs, either detailed information for a specific
VLAN or summary information for all configured VLANs.
show port Displays port information for a selected port or for all ports
Version 2.3 Introduced