Quick Reference Guide

System Configuration Commands | 117
Parameters
Defaults
no description
Mode
Interface Config; Interface Range Ethernet
Command
History
Related
Commands
show inlinepower (stack)
This command shows the status for all switches in a stack that support PoE.
Syntax
show inlinepower
Command Modes
User Exec; Privileged Exec
Command
History
Example
Figure 6-37. Example Output of show inlinepower Command for a Stack
Table 6-17 defines the fields displayed in Figure 6-37.
Related
Commands
type-string
Enter an alphanumeric description.
Version 2.5.1 Introduced
show inlinepower (stack) Display PoE status of stack members.
show inlinepower Display PoE status of designated port.
Version 2.5.1 Introduced
Table 6-17. show interfaces description Command Example Fields
Field Description
Unit The stack member IDs
Status Whether PoE from the switch is enabled (“Auto”) or disabled (Off)
Power(W) The total PoE power budget in watts allotted for the switch
Consumption(W) The current PoE power usage in watts for the switch
Usage(%) The percentage of PoE power used by the switch of the allotted amount
Threshold(%) The allotted percentage of the power that could be made available
Trap Whether PoE SNMP traps are enabled or disabled
Force10-S50V >show inlinepower
Unit Status Power(W) Consumption(W) Usage(%) Threshold(%) Trap
---- ------ -------- -------------- -------- ------------ ----
1 Auto 360 22 6.11 100 enable
inlinepower Enable or disable PoE for the switch.