Quick Reference Guide

116 | System Configuration Commands
www.dell.com | support.dell.com
inlinepower priority
Configure the priority of a port in terms of access to power.
Syntax
inlinepower priority {critical | high | low}
Parameters
Defaults
By default, the power priority of a port is set to low.
Mode
Interface Config; Interface Range Ethernet
Command
History
Related
Commands
inlinepower limit
Configure the power limit of a port (the number of watts available to it if PoE is enabled and other
ports do not have higher priority access to the power budget).
Syntax
inlinepower limit 1-18
Parameters
Defaults
18 (18 watts)
Mode
Interface Config; Interface Range Ethernet
Command
History
Related
Commands
inlinepower type
Enter a power profile description of the port.
Syntax
inlinepower type type-string
critical | high | low Enter critical to enable the selected port to receive power at the highest
priority.
Enter
high to enable the selected port to receive power at the next highest
priority.
Enter
low to set the power priority of the selected port at the lowest level.
Version 2.5.1 Introduced
show inlinepower (stack) Display PoE status of stack members.
show inlinepower Display PoE status of designated port.
1-18
Enter an integer from 1 to 18, representing the maximum number of watts to
make available to the selected port.
Version 2.5.1 Introduced
show inlinepower (stack) Display PoE status of stack members.
show inlinepower Display PoE status of designated port.