Quick Reference Guide

System Configuration Commands | 115
Related
Commands
inlinepower threshold
Configure the amount of Power over Ethernet (PoE) allotted for a specified switch in the S-Series
stack. The amount is specified as a percentage of the total possible power budget.
Syntax
inlinepower threshold 0-100 unit-id
Parameters
Defaults
80 (80% (288 Watts) of the total possible power budget)
Mode
Global Config
Command
History
Related
Commands
inlinepower admin
Enable or disable the Power over Ethernet (PoE) feature on a particular port. Once disabled, that port
can no longer supply power.
Syntax
inlinepower admin {off | auto}
Parameters
Defaults
auto
Mode
Interface Config; Interface Range Ethernet
Command
History
Related
Commands
show inlinepower (stack) Display PoE status of stack members.
show inlinepower Display PoE status of designated port.
0-100
Enter an integer from 1 to 100, representing the percentage of the total power
budget to make available to the specified switch in the S-Series stack. By
default, 80% (288 Watts) of the total possible power budget is available.
unit-id
Enter the stack member ID of the switch to which you want to change the
PoE setting.
Version 2.5.1 Introduced
show inlinepower (stack) Display PoE status of stack members.
show inlinepower Display PoE status of designated port.
off | auto Enter auto to allow the selected port to supply power.
Enter
off to stop the selected port from supplying power.
Version 2.5.1 Introduced
show inlinepower (stack) Display PoE status of stack members.
show inlinepower Display PoE status of designated port.