Quick Reference Guide

104 | System Configuration Commands
www.dell.com | support.dell.com
Syntax
[no] shutdown all
Default
enabled
Mode
Global Config
speed
This command sets the speed and duplex setting for the selected interface.
Syntax
speed {{10 | 100 | 1000} {half-duplex | full-duplex}}
Parameters
Default
auto-negotiate
Mode
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as
(conf-if-range-vlan 10-20)#.
Command
History
Related
Commands
speed all
This command sets the speed and duplex setting for all interfaces.
Syntax
speed all {{10 | 100 | 1000} {half-duplex | full-duplex}}
Parameters
10 half-duplex Enter 10 to set the speed as 10BASE-T, followed by half-duplex for half
duplex.
10 full-duplex Enter 10 to set the speed as 10BASE-T, followed by full-duplex for full duplex.
100 half-duplex Enter 100 to set the speed as 100BASE-T, followed by half-duplex for half
duplex.
100 full-duplex Enter 100 to set the speed as 100BASE-T, followed by full-duplex for full
duplex.
1000 half-duplex Enter 1000 to set the speed as 1000BASE-T, followed by half-duplex for half
duplex.
1000 full-duplex Enter 1000 to set the speed as 1000BASE-T, followed by full-duplex for full
duplex.
Version 2.3 Added Interface Range mode.
auto-negotiate Enables automatic speed negotiation on a port.
interface range Defines an interface range and accesses the Interface Range mode
interface Identifies an interface and enters the Interface Config mode.
10 half-duplex Enter 10 to set the speed as 10BASE-T, followed by half-duplex for half
duplex.
10 full-duplex Enter 10 to set the speed as 10BASE-T, followed by full-duplex for full duplex.