Quick Reference Guide

Stacking S-Series Switches | 97
Figure 5-64. Using the show bootvar Command within a Stack
2. After executing the reload 2 command to reboot Unit 2, use the show switch command to verify that
the stack is running the new code:
Figure 5-65. Verifying Stack Sequencing after a Reload with show switch and show stack
Commands
Force10-S50 #boot system 2 image2
Activating image image2 ..
Force10-S50 #show bootvar
Image Descriptions
image1 : default image
image2 :
Images currently available on Flash
--------------------------------------------------------------------
unit image1 image2 current-active next-active
--------------------------------------------------------------------
1 F.10.20.1 <none> image1 image1
2 F.10.16.2 F.10.20.1 image1 image2
Force10-S50 #reload 2
Are you sure you want to reload the switch? (y/n) y
Reloading switch 2.
................
Force10-S50 #STACK: master on 0:1:e8:d5:c2:21 (2 cpus, 12 units)
Trying to attach more units.....
STACK: master on 0:1:e8:d5:c2:21 (2 cpus, 12 units)
STACK: attach 7 units on 1 cpu
This switch is manager of the stack.
Force10-S50 >show switch
Management Preconfig Plugged-in Switch Code
Switch Status Model ID Model ID Status Version
------ ------------ ---------------- ---------------- --------------- --------
1 Mgmt Switch SA-01-GE-48T SA-01-GE-48T OK F.10.20.1
2 Stack Member SA-01-GE-48T SA-01-GE-48T OK F.10.20.1
Force10-S50 #show stack
Configured Running
Stack Stack Link Link
Unit Interface Mode Mode Status Speed (Gb/s)
---- ---------------- ---------- ---------- ------------ ------------
1 Stack Port A N/A Stack Link Up 10
1 Stack Port B N/A Stack Link Up 10
2 Stack Port A N/A Stack Link Up 10
2 Stack Port B N/A Stack Link Up 10