Quick Reference Guide

Management | 81
Example #5: show sntp server
Figure 4-53. Using the show sntp server Command
Gathering Details about the Switch
In addition to the show commands demonstrated in this chapter, the section Verifying Details about the
Switch on page 32 in the Getting Started chapter contains a good summary of
show commands useful for
gathering typical switch information. See also the section Using show Commands for Stacking Information
on page 98 in the Stacking chapter.
Force10 #show sntp server
Server IP Address: 10.11.8.6
Server Type: ipv4
Server Stratum: 3
Server Reference Id: NTP Srv: 128.4.1.2
Server Mode: Server
Server Maximum Entries: 3
Server Current Entries: 1
SNTP Servers
------------
IP Address: 10.11.8.6
Address Type: IPV4
Priority: 1
Version: 4
Port: 123
Last Update Time: JUNE 18 04:59:13 2005
Last Attempt Time: JUNE 18 11:59:33 2005
Last Update Status: Other
Total Unicast Requests: 1111
Failed Unicast Requests: 361