Quick Reference Guide

Getting Started | 37
Figure 3-9. Creating a User and a Password
Showing and Removing Created Users
An alternative to the no username command shown above is to use the clear pass command to delete all
created users. The following example shows the
show users command and the clear pass command:
Figure 3-10. Showing Created Users
Setting SNMP Read/Write Access
The command users snmpv3 accessmode username {readonly | readwrite} enables you to set SNMP
privileges for specific users. As used above (Showing and Removing Created Users on page 37), the
show
users command displays the read and write privileges for each defined user:
Note: SFTOS 2.5.1.3 adds support for the following special characters: , . { } | , in other words,
period, comma, open bracket, close bracket, and bar.
Force10 (Config)#username w_turner passwd willspwd
User login name and password are set.
Force10 (Config)#no username w_turner
Force10 (Config)#username w_turner passwd newpwd
User login name and password are set.Password Changed!
Force10 #show users
SNMPv3 SNMPv3 SNMPv3
User Name User Access Mode Access Mode Authentication Encryption
---------- ---------------- ----------- -------------- ----------
admin Read/Write Read/Write None None
w_turner Read/Write Read Only None None
Force10 #clear pass
Are you sure you want to reset all passwords? (y/n)y
Passwords Reset!
Force10 (Config)#users snmpv3 accessmode student2 readwrite
Force10 #show users
SNMPv3 SNMPv3 SNMPv3
User Name User Access Mode Access Mode Authentication Encryption
---------- ---------------- ----------- -------------- ----------
admin Read/Write Read/Write None None
student1 Read Only Read Only None None
student2 Read Only Read/Write None None