Quick Reference Guide

34 | Getting Started
www.dell.com | support.dell.com
Showing Network Settings
Execute the show interface managementethernet command from either the User Exec or Privileged Exec
modes. The resulting display, as shown in the example below, displays all the settings relating to IP-based
management connections to the switch. The data includes the management IP address, subnet mask,
default gateway, MAC information, etc., as shown below:
Figure 3-7. Using the show network Command to Display Network Settings
For details on setting up the management address, see Setting the Management IP Address on page 39. See
also Setting up a Management Connection to the Switch on page 28.
Displaying Supported Features and System Up-time
The following is an example of using show version to display all supported features and system up-time:
Note: SFTOS v. 2.3 replaced the show network command with show interface
managementethernet.
Force10 #show interface managementethernet
IP Address..................................... 10.10.1.151
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.10.1.254
Burned In MAC Address.......................... 00:01:E8:D5:A0:39
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
Web Mode....................................... Enable
Java Mode...................................... Disable