Quick Reference Guide

272 | Layer 3 Routing
www.dell.com | support.dell.com
Figure 17-254. VRRP Example Network Configuration
Configuring VRRP: Master Router (Router 1)
1. Enable routing for Router 1. IP forwarding will then be enabled by default.
Figure 17-255. Enabling Routing for a Switch
2. VRRP is enabled by default for the router. If VRRP has been disabled, enable it:
Figure 17-256. Enabling VRRP for a Switch
3. Configure the port on Router 1 that will participate in the VRRP group:
Port 0/2
192.150.2.1
/24
Virtual Router ID 20
Virtual Addr. 192.150.2.1
Port 0/4
192.150.2.4/24
Virtual Router ID 20
Virtual Addr. 192.150.2.1
Hosts
Layer 3 Switch acting
as Router 1
Layer 2 Switch
Layer 3 Switch acting
as Router 2
Force10 # config
Force10 (Config)#ip routing
Force10 (Config)#exit
Force10 (Config)#ip vrrp
Force10 (Config)#exit