Quick Reference Guide

Layer 3 Routing | 267
Figure 17-249. Output of the show ip ospf interface vlan Command
VLAN Routing RIP Configuration
The two versions of the Routing Information Protocol (RIP) are described in RIP Configuration on
page 255. The following example demonstrates how to add support for RIPv2 to the configuration created
in the previous base VLAN routing example (Example of creating a routed VLAN between switches on
page 263). A second router, using port routing rather than VLAN routing, has been added to the network.
Figure 17-250. RIP for VLAN Routing Example Network Diagram
Force10 #show ip ospf interface vlan 10
IP Address..................................... 10.1.1.1
Subnet Mask.................................... 255.255.255.0
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.2
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ MD5
Authentication Key............................. "force10"
Authentication Key ID.......................... 10
Metric Cost.................................... 1 (computed)
OSPF Mtu-ignore................................ Disable
OSPF Interface Type............................ broadcast
State.......................................... backup-designated-router
Designated Router.............................. 2.2.2.2
Backup Designated Router....................... 1.1.1.1
Number of Link Events.......................... 3
Force10 #