Quick Reference Guide

254 | Layer 3 Routing
www.dell.com | support.dell.com
Verifying the configuration
Verify the configuration with these show commands, in Privileged Exec or User Exec modes:
Use the
show ip igmp-proxy command to display host interface status parameters. It displays operational
parameters only when IGMP Proxy is enabled, as shown in Figure 17-225
Figure 17-224. Using the show ip igmp-proxy Command
• show ip igmp-proxy groups command: Figure 17-226
• show ip igmp-proxy interface command: Figure 17-227
Other relevant
show commands include:
•
show ip igmp-proxy interface {unit/slot/port | vlan 1-3965}
•
show ip igmp-proxy groups {unit/slot/port [detail] | 1-3965 [detail]}
•
show ip igmp-proxy groups detail
Figure 17-225. Using the show ip igmp-proxy Command
Figure 17-226. Using the show ip igmp-proxy groups Command
Force10 #show ip igmp-proxy
Admin Mode..................................... Enable
Operational Mode............................... Disable
Force10-S50V#show ip igmp-proxy
VLAN .......................................... 2
Admin Mode..................................... Enable
Operational Mode............................... Enable
Version........................................ 3
Number of Multicast Groups..................... 0
Unsolicited Report Interval.................... 1
Querier IP Address on Proxy Interface.......... 0.0.0.0
Older Version 1 Querier Timeout................ 0
Older Version 2 Querier Timeout................ 0
Proxy Start Frequency.......................... 3
Force10-S50V#show ip igmp-proxy groups
VLAN .......................................... 2
Group Address Last Reporter Up Time Member State Filter Mode Sources
--------------- --------------- ------- ------------ ----------- -------