Quick Reference Guide

Port Mirroring | 245
Using other commands that show port mirroring status
You can use the show port all command to show all existing probe ports and mirrored ports, along with
their operational status:
Figure 16-215. Example of show port all Showing Port Mirroring
Figure 16-216. Using show running-config Command Output to Show Port Mirroring
Also, you can use the show port interface command for information on whether a specific port is the mirror
or probe port and what is enabled or disabled on it.
Figure 16-217. Using the show port command
Force10 S50 #show port all
Admin Physical Physical Link Link LACP
Interface Type Mode Mode Status Status Trap Mode
---------- ------ ------- ---------- ---------- ------ ------- -------
1/0/1 Mirror Enable Auto 100 Full Up Enable Enable
1/0/2 Disable Auto Down Enable Enable
2/0/24 Disable Auto Down Enable Enable
2/0/25 Disable Auto Down Enable Enable
2/0/26 Probe Enable Auto 1000 Full Up Enable Enable
2/0/27 Disable Auto Down Enable Enable
2/0/28 Disable Auto Down Enable Enable
Force10 S50 #show running-config
!---------<snip>---------------!
monitor session 1 destination interface 2/0/26
monitor session 1 source interface 1/0/1
monitor session 1 mode
Force10 #show port 1/0/4
Admin PhysicalPhysicalLinkLinkLACP
Intf Type Mode Mode StatusStatusTrapMode
---- ---- ------ ------------------------------
1/0/4 Mirror Enable Auto Down EnableEnable
Force10 #show port 1/0/5
Admin PhysicalPhysicalLinkLinkLACP
Intf Type Mode Mode StatusStatusTrapMode
---- ---- ------ ------------------------------
1/0/5 Probe Enable Auto Down EnableEnable