Quick Reference Guide

244 | Port Mirroring
www.dell.com | support.dell.com
Stopping the mirroring session and removing probe and mirrored ports
Figure 16-213. Command Examples: Removing port mirroring configuration
Verifying Port Mirroring
Use the following commands from the Privileged Exec mode to inspect port mirroring settings:
•
show monitor session 1: See Figure 16-214
•
show port all: See Figure 16-214
•
show running-config: See Figure 16-216
•
show port: See Figure 16-217
Verifying port mirroring session status
Figure 16-214. show monitor session 1 Command Output
In Figure 16-214, note that the probe (destination) port and mirrored ports are in different stack members.
Note: Alternatively, you can use the no monitor command to disable port mirroring, which
automatically removes the mirror and probe configuration from the source and destination
ports. Then, reenabling port mirroring requires designating the source and destination ports
again.
Force10 (Config)#no monitor session 1 mode
Force10 (Config)#no monitor session source
Force10 (Config)#no monitor session destination
Force10 (Config)#no monitor
Force10 #show monitor session 1
Session ID Admin Mode Probe Port Mirrored Port
---------- ---------- ---------- -------------
1 Enable 2/0/26 1/0/1
1/0/11