Quick Reference Guide

222 | VLANs
www.dell.com | support.dell.com
Figure 14-181. Using the show vlan id Command
Notes:
• The ‘G’ indicates that this VLAN was dynamically created via GVRP on R1.
• If you execute
show vlan id 3 on R2, you will not see the G in the output, because the VLAN was
actually configured on R2, not dynamically negotiated.
• To make the VLAN permanent on R1, use the
makestatic command under interface vlan 3.
Displaying GARP, GVRP, GMRP Properties
These Privileged Exec and User Exec mode commands display GARP, GVRP, and GMRP information:
•
show garp (Figure 14-182)
— Displays admin mode for GVRP and GMRP
• show gmrp configuration {unit/slot/port | all}
• show gvrp configuration {unit/slot/port | all} (Figure 14-182)
— Port admin mode for GVRP and GMRP
— Timer values
See also the
show vlan id command shown above (Figure 14-181).
show garp and show gvrp configuration all commands
Figure 14-182. Using the show garp and show gvrp configuration all Commands
(R1) #show vlan id 3
Codes: * - Default VLAN, G - GVRP VLANs, E - Ethernet interface
Vlan Id Status Q Ports
------- --------- - --------
G 3 Active T E 1/0/2
(R2) #show garp
GMRP Admin Mode................................ Disable
GVRP Admin Mode................................ Enable
(R2) #show gvrp configuration all
Join Leave LeaveAll Port
Slot/Port Timer Timer Timer GVRP Mode
----------- ------- ------- ---------- -----------
1/0/1 20 60 1000 Enabled
1/0/2 20 60 1000 Enabled
1/0/3 20 60 1000 Enabled
1/0/4 20 60 1000 Enabled
1/0/5 20 60 1000 Enabled
1/0/6 20 60 1000 Enabled
!---------output truncated--------!