Quick Reference Guide

176 | Link Aggregation
www.dell.com | support.dell.com
Verify the status of the LAG as dynamic created through LACP:
Figure 11-134. Displaying Details on a LAG with the show interface port-channel Command
Displaying LAGs (Port Channels)
In SFTOS v. 2.5.1, the show port-channel all command is replaced by the show interface port-channel
command. An example of the
show interface port-channel 1-128 option is shown in Figure 11-134,
above. The
show interface port-channel brief version is shown in Figure 11-135.
Figure 11-135. Displaying LAGs with the show interfaces port-channel brief Command
Force10 (Config)#exit
Force10#show interface port-channel 2
Description....................................
MAC Address.................................... 00:01:E8:D5:A0:81
MTU............................................ 1518
Packets RX and TX 64 Octets.................... 0
Packets RX and TX 65-127 Octets................ 0
Packets RX and TX 128-255 Octets............... 0
Packets RX and TX 256-511 Octets............... 0
Packets RX and TX 512-1023 Octets.............. 0
Packets RX and TX 1024-1518 Octets............. 0
Packets RX and TX 1519-1522 Octets............. 0
Packets RX and TX 1523-2047 Octets............. 0
Packets RX and TX 2048-4095 Octets............. 0
Packets RX and TX 4096-9216 Octets............. 0
Jabbers Received............................... 0
Fragments Received............................. 0
Undersize Received............................. 0
Alignment Errors............................... 0
FCS Errors..................................... 0
Overruns....................................... 0
Unicast Packets Received....................... 0
--More-- or (q)uit
Force10#show interface port-channel brief
Codes: L - LACP Port-channel
LAG Status Ports
--- ------ -------
1 Up 1/0/3 (Up)
1/0/4 (Up)
1/0/5 (Up)