Quick Reference Guide

Link Aggregation | 169
The CLI commands in the Interface Port Channel Config mode include the following:
• Add to the selected LAG (or delete from it), one or more ports:
—[no] channel-member unit/slot/port–unit/slot/port,unit/slot/port
• Enter a description for the selected LAG:
—[
no] description
• Configure the priority for untagged frames:
— dot1p-priority 0-7
• Set the maximum transmission unit (MTU) size (in bytes) for the selected LAG:
—[
no] mtu 1518-9216
• Attach a specified ACL to the selected LAG (and, optionally, to also enter a sequence number (from
1-4294967295) that indicates the order of this ACL relative to other ACLs assigned to this LAG):
—
ip access-group 1–199 [1-4294967295] in
• Attach a MAC ACL identified by name to the selected LAG in the ingress direction. The 1-4294967295
option is as described above:
—
mac access-group name [1-4294967295]
• Enable the support of static link aggregations on the LAG. By default, the static capability for all LAGs
is disabled:
— protocol static
• Reenable the LACP on the selected LAG:
— protocol lacp
• Enable or disable the LAG:
—[
no] shutdown
• Enable or disable link status traps for the LAG:
—[
no] snmp trap link-status
• Set the spanning-tree operational mode on the selected LAG:
—[
no] spanning-tree
• Set or clear the CST cost for the LAG:
—[
no] spanning tree 0 cost 1-65535
• Set or clear the CST priority for the LAG.
—[
no] spanning tree 0 priority 0-15
• Associate or disassociate a multiple spanning tree instance with cost to the LAG:
—[
no] spanning-tree MSTi 0-63 cost 1-2000000
• Set or clear the priority associated with the multiple spanning tree instance for the LAG.
—[
no] spanning-tree MSTi 0-63 priority 0-240
• Enable or disable spanning-tree MSTP edge-port mode:
—[
no] spanning-tree mstp edge-port