Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentForce10 S2410-01-10GE-24P
111112113114115116117118119120
Configuring Interfaces | 119
— Lag—This port is a member of a port-channel (LAG).
— Probe—This port is a probe port.
• The Admin Mode column shows if the port is enabled or shut down. To enable the port, see Enabling
an Interface on page 120.
• The Physical Mode column displays Auto if the port is set to auto-negotiate (Duplex mode and speed
will be set from the auto-negotiation process.) To force a change in the setting, see Configuring Speed
and Duplex Mode on page 120.
• Physical Status—Indicates the port speed and duplex mode.
• The Link Status column displays Up, Down, or Detach.
The two optional 10G ports (numbered as ports 49 and 50) in the S50 always appear in the list, so
when they are not installed, this column lists them as Detach. Rather than physically inspecting the
rear slot to determine if the 10G module is installed, you can use the
show slot command, as shown in
Figure 7-85, to learn more.
• Link Trap—This object determines whether or not to send a trap when link status changes. The factory
default is enabled.
• LACP Mode—Displays whether LACP is enabled or dis
abled on this port.
The SA-01-10GE-2P model number shown in the show slot report is that of the 10G module.
Figure 7-85. 10G Module Listed by the show slot Command
Note, in the show slot report above, that the presence of a 10G module in stack member 1 is indicated both
by the Status field indicating Full and the Power State field indicating Enable. In contrast, the empty slots
in stack members 2 and 3 are indicated by the Status field indicating Empty and the Power State field
indicating Disable.
After you determine the status of physical interfaces, you can access the Interface Config mode to
configure the designated interface.
Force10 #show slot
Admin Power Configured Card Hot Power
Slot Status State State Model ID Pluggable Down
----- ------ ------- ------- -------------------------------- --------- -----
1/0 Full Enable Enable SA-01-10GE-2P No No
2/0 Empty Enable Disable SA-01-10GE-2P No No
3/0 Empty Enable Disable SA-01-10GE-2P No No