Quick Reference Guide

Configuring Interfaces | 115
Switch
The show interfaces cos-queue [unit/slot/port], with and without the unit/slot/port parameter, produces almost
the same report — one version for the interface and the other for the switch. The version of the report
generated with the
unit/slot/port parameter is shown in Figure 7-81.
Figure 7-81. Using the show interfaces cos-queue Command for Port QoS Details
Use the show interface ethernet unit/slot/port command for detailed packet information for the designated
port, as shown in Figure 7-82 on page 116.
Force10 #show interface ethernet switchport
Total Packets Received (Octets)................ 0
Unicast Packets Received....................... 0
Multicast Packets Received..................... 0
Broadcast Packets Received..................... 0
Receive Packets Discarded...................... 0
Octets Transmitted............................. 0
Packets Transmitted Without Errors............. 0
Unicast Packets Transmitted.................... 0
Multicast Packets Transmitted.................. 0
Broadcast Packets Transmitted.................. 0
Transmit Packets Discarded..................... 0
Most Address Entries Ever Used................. 1
Address Entries Currently in Use............... 1
Maximum VLAN Entries........................... 1024
Most VLAN Entries Ever Used.................... 1
Static VLAN Entries............................ 1
Dynamic VLAN Entries........................... 0
VLAN Deletes................................... 0
Time Since Counters Last Cleared............... 0 day 0 hr 25 min 45 sec
Force10 #
Force10 #show interfaces cos-queue 1/0/1
Interface...................................... 1/0/1
Interface Shaping Rate......................... 0
Queue Id Min. Bandwidth Scheduler Type Queue Management Type
-------- -------------- -------------- ---------------------
0 0 Weighted Tail Drop
1 0 Weighted Tail Drop
2 0 Weighted Tail Drop
3 0 Weighted Tail Drop
4 0 Weighted Tail Drop
5 0 Weighted Tail Drop
6 0 Weighted Tail Drop
Force10 #