Reference Guide

Quality of Service (QoS) | 475
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
Defaults
none
Command Modes
CONFIGURATION
Command
History
Usage
Information
Output policy map is used to assign traffic to different flows using QoS policy. This command enables
the policy-map-output configuration mode (conf-policy-map-out).
Related
Commands
qos-policy-input
Create a QoS input policy on the router.
Syntax
qos-policy-input qos-policy-name [layer2]
To remove an existing input QoS policy from the router, use the no qos-policy-input qos-policy-name
[layer2] command.
Parameters
Defaults
Layer 3
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use this command to specify the name of the input QoS policy. After input policy is specified,
rate-police can be defined. This command enables the qos-policy-input configuration mode—
(conf-qos-policy-in).
policy-map-name
Enter the name for the policy map in character format (16 characters
maximum).
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
service-queue Assigns a class map and QoS policy to different queues.
policy-aggregate Allows an aggregate method of configuring per-port QoS via policy maps.
service-policy output Applies an output policy map to the selected interface.
qos-policy-name
Enter your input QoS policy name in character format (32 character
maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map.
Default: Layer 3
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module