Reference Guide

Interfaces | 237
Example
Figure 14-1. clear counters Command Example
Related
Commands
clear dampening
Clear the dampening counters on all the interfaces or just the specified interface.
Syntax
clear dampening [interface]
Parameters
Defaults
Without a specific interface specified, the command clears all interface dampening counters
Command Modes
EXEC Privilege
Command
History
Usage
Information
On the MXL Switch, after you enter the clear counters command and verify the results with the show
interfaces command, the line rate is not reset to 0.00%.
Example
Figure 14-2. clear dampening Command Example
Related
Commands
cx4-cable-length
Configure the length of the cable to be connected to the selected CX4 port.
Syntax
[no] cx4-cable-length {long | medium | short}
FTOS#clear counters
Clear counters on all interfaces [confirm]
mac learning-limit Limit the maximum number of MAC addresses (static + dynamic) learned on a
selected interface.
show interfaces Display information on a specific physical interface or virtual interface.
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keyword
port-channel followed
by a number. Range: 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#clear dampening tengigabitethernet 1/2
Clear dampening counters on tengig 1/2 [confirm] y
FTOS#
show interfaces dampening Displays interface dampening information.
dampening Configures dampening on an interface.