Reference Guide

236 | Interfaces
www.dell.com | support.dell.com
• show config (from INTERFACE RANGE mode)
• show interfaces
• show interfaces configured
• show interfaces dampening
• show interfaces description
• show interfaces stack-unit
• show interfaces status
• show interfaces switchport
• show interfaces transceiver
• show range
• shutdown
• speed (for 1000/10000/auto interfaces)
• stack-unit portmode
clear counters
Clear the counters used in the show interfaces commands for all VRRP groups, VLANs, and physical
interfaces, or selected ones.
Syntax
clear counters [interface] [vrrp [{vrid | vrf instance}] | learning-limit]
Parameters
Defaults
Without a specific interface specified, the command clears all interface counters.
Command Modes
EXEC Privilege
Command
History
interface
(OPTIONAL) Enter any of the following keywords and slot/port or number to clear
counters from a specified interface:
• For a Loopback interface, enter the keyword
loopback followed by a number from
0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number. Range: 1-128
• For the management interface on the stack-unit, enter the keyword
managementethernet followed by slot/port information. The slot range is 0-1,
and the port range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
vrrp
[vrid]
(OPTIONAL) Enter the keyword vrrp to clear the counters of all VRRP groups. To
clear the counters of a specified group, enter a
vrid number from 1 to 255.
vrrp
[vrf instance]
(OPTIONAL): Enter the keyword vrrp to clear counters for all VRRP groups. To clear
the counters of VRRP groups in a specified VRF instance, enter the name of the
instance (32 characters maximum).
learning-limit (OPTIONAL) Enter the keyword learning-limit to clear unknown source address (SA)
drop counters when MAC learning limit is configured on the interface.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module