Deployment Guide

To remove the congured FCoE priority, use the no fcoe priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x8
Command Modes PROTOCOL LLDP
Command History
Version 9.2(0.0) Introduced on the M I/O Aggregator.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is available at the global level only.
iscsi priority-bits
Congure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
Syntax
iscsi priority-bits priority-bitmap
To remove the congured iSCSI priority, use the no iscsi priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x10
Command Modes PROTOCOL LLDP
Command History
Version 9.2(0.0) Introduced on the M I/O Aggregator.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is available at the global level only.
priority
Congure the priority for the PFC threshold to be allocated to the buer space parameters.
Syntax
priority value buffer-size size pause-threshold threshold-value resume-offset
threshold-value shared-threshold-weight size
Parameters
priority Specify the priority of the queue for which the buer space settings apply
value Enter a number in the range of 0 to 7 to denote the priority to be allocated to the dynamic
buer control mechanism
buer-size Ingress buer size
size Size of the ingress buer in KB. Enter a number in the range of 0 to 7787. The default is
45 KB.
pause-threshold Buer limit for pause frames to be sent
376 Data Center Bridging (DCB)