Reference Guide

402 | Interfaces
www.dell.com | support.dell.com
Use the show ip interfaces brief command in EXEC Privilege mode to view which interfaces are enabled for
Layer 3 data transmission. In Figure 22-2, the TenGigabitEthernet interface 1/5 is in Layer 3 mode because
an IP address has been assigned to it and the interface’s status is operationally up.
Figure 22-2. show ip interfaces brief Command Example (Partial)
Use the show interfaces configured command in EXEC Privilege mode to view only configured interfaces.
To determine which physical interfaces are available, use the
show running-config command in EXEC mode.
This command displays all physical interfaces available on the switch (Figure 22-3).
Figure 22-3. show running-config Command Example (Partial)
FTOS#show ip interface brief
Interface IP-Address OK? Method Status Protocol
TenGigabitEthernet 1/0 unassigned NO Manual administratively down down
TenGigabitEthernet 1/1 unassigned NO Manual administratively down down
TenGigabitEthernet 1/2 unassigned YES Manual up up
TenGigabitEthernet 1/3 unassigned YES Manual up up
TenGigabitEthernet 1/4 unassigned YES Manual up up
TenGigabitEthernet 1/5 10.10.10.1 YES Manual up up
TenGigabitEthernet 1/6 unassigned NO Manual administratively down down
TenGigabitEthernet 1/7 unassigned NO Manual administratively down down
TenGigabitEthernet 1/8 unassigned NO Manual administratively down down
FTOS#show running
Current Configuration ...
!
interface TenGigabitEthernet 9/6
no ip address
shutdown
!
interface TenGigabitEthernet 9/7
no ip address
shutdown
!
interface TenGigabitEthernet 9/8
no ip address
shutdown
!
interface TenGigabitEthernet 9/9
no ip address
shutdown