Reference Guide

Equal Cost Multi-Path (ECMP) | 345
Use the ip ecmp-group path-fallback command to enable or disable the feature.
Figure 16-1. Command example: ip ecmp-group maximum-paths
Task Command Syntax Command Mode
Configure the maximum number of paths
per ECMP group
ip ecmp-group maximum-paths {2-64}
CONFIGURATION
Enable ECMP group path management
ip ecmp-group path-fallback
CONFIGURATION
Note: You must save the new ECMP settings to the startup-config (
write-mem) then reload the system for the
new settings to take effect.
FTOS(conf)#ip ecmp-group maximum-paths 3
User configuration has been changed. Save the configuration and reload to take effect
FTOS(conf)#