Reference Guide

94 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Command
History
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-assigning new sequence
numbers to entries of an existing prefix list.
Related
Commands
show config
Display the current ACL configuration.
Syntax
show config
Command Modes
CONFIGURATION-IP ACCESS-LIST-STANDARD
CONFIGURATION-IP ACCESS-LIST-EXTENDED
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Example
Figure 6-2. show config Command Example
Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended) and do not
have mode-specific options. When an access-list (ACL) is created without any rule and then applied to
an interface, ACL behavior reflects an implicit permit.
The MXL 10/40GbE Switch IO Module platform supports both ingress and egress IP ACLs.
The following commands allow you to clear, display, and assign IP ACL configurations.
• access-class
• clear counters ip access-group
• ip access-group
• show ip access-lists
• show ip accounting access-list
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
seq Assign a sequence number to a deny or permit filter in an IP access list while
creating the filter.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf-ext-nacl)#show conf
!
ip access-list extended patches
FTOS(conf-ext-nacl)#
Note: See also Commands Common to all ACL Types.