Reference Guide

92 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Defaults
Not enabled.
Command Modes
CONFIGURATION-IP ACCESS-LIST-STANDARD
CONFIGURATION-IP ACCESS-LIST-EXTENDED
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
remark
Enter a description for an ACL entry.
Syntax
remark [remark-number] [description]
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION-IP ACCESS-LIST-STANDARD
CONFIGURATION-IP ACCESS-LIST-EXTENDED
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Usage
Information
The remark command is available in each ACL mode. You can configure up to 4294967290 remarks
in a given ACL.
The following example shows the use of the remark command twice within CONFIGURATION-IP
ACCESS-LIST-STANDARD mode. Here, the same sequence number was used for the remark and for
an associated ACL rule. The remark precedes the rule in the running-config because it is assumed that
the remark is for the rule with the same sequence number, or the group of rules, that follow the remark.
Example
Figure 6-1. remark Command Example
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
remark-number
Enter the remark number. Note that you can use the same sequence number
for the remark and an ACL rule.
Range: 0 to 4294967290
description
Enter a description of up to 80 characters.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf-std-nacl)#remark 10 Deny rest of the traffic
FTOS(conf-std-nacl)#remark 5 Permit traffic from XYZ Inc.
FTOS(conf-std-nacl)#show config
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24
remark 10 Deny rest of the traffic
seq 10 Deny any
FTOS(conf-std-nacl)#