Reference Guide

666 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Defaults
VRRP is enabled.
Command Modes
VRRP
Command
History
Usage
Information
To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-address command
and enter no disable.
Related
Commands
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the
initialization of the VRRP MASTER, the new switch can stabilize its routing tables.
Syntax
hold-time seconds
To return to the default value, use the no hold-time command.
Parameters
Defaults
zero (0) seconds
Command Modes
VRRP
Command
History
Usage
Information
If a switch is a MASTER and you change the hold timer, you must disable and re-enable VRRP for the
new hold timer value to take effect.
Related
Commands
preempt
Permit a BACKUP router with a higher priority value to preempt or become the MASTER router.
Syntax
preempt
To prohibit preemption, use the no preempt command.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
virtual-address Specifies the IP address of the virtual router.
seconds
Enter a number of seconds.
Range: 0 to 65535.
Default: zero (0) seconds.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
disable Disables a VRRP group.