Reference Guide

574 | sFlow
www.dell.com | support.dell.com
sflow extended-switch enable
Enable packing information on a switch only.
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable] command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS version 7.8.1.0 and later enhances the sflow implementation for real time traffic analysis to
provide extended gateway information in cases where the destination IP addresses are learned by
different routing protocols and for cases where the destination is reachable over ECMP.
Related
Commands
sflow polling-interval (Global)
Set the sFlow polling interval at a global level.
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
Defaults
20 seconds
Command Modes
CONFIGURATION
Command
History
Usage
Information
The polling interval for an interface is the maximum number of seconds between successive samples of
counters to be sent to the collector. This command changes the global default counter polling (20 seconds)
interval. You can configure an interface to use a different polling interval.
Related
Commands
enable Enter the keyword enable to enable global extended information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
show sflow Displays the sFlow configuration
interval value
Enter the interval value in seconds.
Range: 15 to 86400 seconds
Default: 20 seconds
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
sflow polling-interval (Interface) Sets the polling interval for an interface