Reference Guide

Security | 553
Command
History
ip tacacs source-interface
Specify an interface’s IP address as the source IP address for TACACS+ connections.
Syntax
ip tacacs source-interface interface
To delete a source interface, use the no ip tacacs source-interface command.
Parameters
Defaults
Not configured.
Command Mode
CONFIGURATION
Command
History
tacacs-server host
Specify a TACACS+ host.
Syntax
tacacs-server host {hostname | ipv4-address} [port number] [timeout seconds] [key key]
Parameters
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface
Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword
loopback followed by a number
from zero (0) to 16838.
• For the Null interface, enter the keywords
null 0.
• For a Port Channel interface, enter the keyword port-channel followed by a
number:
Range: 1 to 128
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to
4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
hostname
Enter the name of the TACACS+ server host.
ipv4-address
Enter the IPv4 address (A.B.C.D) of the TACACS+ server host.
port number (OPTIONAL) Enter the keyword port followed by a number as the port to be
used by the TACACS+ server.
Range: zero (0) to 65535
Default: 49