Reference Guide

Routing Information Protocol (RIP) | 503
Example
Figure 26-1. router rip Command Example
Related
Commands
show config
Display the changes you made to the RIP configuration. Default values are not shown.
Syntax
show config
Command Modes
ROUTER RIP
Command
History
Example
Figure 26-2. show config Command Example in ROUTER RIP Mode
show ip rip database
Display the routes learned by RIP. If the switch learned no RIP routes, no output is generated.
Syntax
show ip rip database [ip-address mask]
Parameters
Command Modes
EXEC Privilege
Command
History
FTOS(conf)#router rip
FTOS(conf-router_rip)#
network Enable RIP.
exit Return to the CONFIGURATION mode.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf-router_rip)#show config
!
router rip
network 172.31.0.0
passive-interface TenGigabitEthernet 0/1
FTOS(conf-router_rip)#
ip-address
(OPTIONAL) Specify an IP address in dotted decimal format to view RIP information on
that network only.
If you enter an IP address, you must also enter a mask for that IP address.
mask
(OPTIONAL) Specify a mask, in /network format, for the IP address.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module