Reference Guide

476 | Quality of Service (QoS)
www.dell.com | support.dell.com
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use this command to specify the name of the input QoS policy. After input policy is specified,
rate-police can be defined. This command enables the qos-policy-input configuration mode—
(conf-qos-policy-in).
When changing a service-queue configuration in a QoS policy map, all QoS rules are deleted and
re-added automatically to ensure that the order of the rules is maintained. As a result, the Matched
Packets value shown in the “show qos statistics” command is reset.
Related
Commands
qos-policy-output
Create a QoS output policy.
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-policy-name command.
Parameters
Defaults
none
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use this command to specify the name of the output QoS policy. After output policy is specified,
rate-limit, bandwidth-percentage, and WRED can be defined. This command enables the
qos-policy-output configuration mode—(conf-qos-policy-out).
When changing a service-queue configuration in a QoS policy map, all QoS rules are deleted and
re-added automatically to ensure that the order of the rules is maintained. As a result, the Matched
Packets value shown in the show qos statistics command is reset.
Related
Commands
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
rate-police Incoming traffic policing function
qos-policy-name
Enter your output QoS policy name in character format (32 character
maximum).
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
bandwidth-percentage
Assigns weight to class/queue percentage.
wred
Assigns yellow or green drop precedence.